Dell PowerEdge FX2/FX2s - Manual (Page 125)

Dell(conf-if-te-0/2)#vlan tagged 2,3-4
2. Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through
an individual interface
INTERFACE mode
Dell(conf-if-te-0/2)#switchport
This switchport configuration is allowed only in PMUX mode. In all other modes, it is automatically
configured.
3. Verify the manually configured VLAN membership (show interfaces switchport interface command).
EXEC mode
Dell(conf)# interface tengigabitethernet 0/1
Dell(conf-if-te-0/1)#switchport
Dell(conf-if-te-0/1)# vlan tagged 2-5,100,4010
Dell#show interfaces switchport te 0/1
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V -
VLT tagged
Name: TenGigabitEthernet 0/1
802.1QTagged: True
Vlan membership:
Q Vlans
T 2-5,100,4010
Dell#
Deleting or Disabling a Port Channel
To delete or disable a port channel, use the following commands.
• Delete a port channel.
CONFIGURATION mode
no interface portchannel channel-number
• Disable a port channel.
shutdown
When you disable a port channel, all interfaces within the port channel are operationally down also.
Configuring Auto LAG
You can enable or disable auto LAG on the server-facing interfaces. By default, auto LAG is enabled. This
functionality is supported on the Aggregator in Standalone, Stacking, and VLT modes.
To configure auto LAG, use the following commands:
1. Enable the auto LAG on all the server ports.
CONFIGURATION mode
io-aggregator auto-lag enable
Link Aggregation 125