Dell PowerEdge FX2/FX2s - Manual (Page 247)

NUM Status Description Q Ports
10 Active U Po110(Te 0/8)
T Po100(Te 0/3,4)
Verifying a Port-Channel Connection to a VLT Domain (From an Attached Access Switch)
On an access device, verify the port-channel connection to a VLT domain.
Dell_TORswitch(conf)# show running-config interface port-channel 11
!
interface Port-channel 11
switchport
channel-member TenGigE 0/1,2
no shutdown
Troubleshooting VLT
To help troubleshoot different VLT issues that may occur, use the following information.
NOTE: For information on VLT Failure mode timing and its impact, contact your Dell Networking
representative.
Table 19. Troubleshooting VLT
Description Behavior at Peer Up Behavior During Run
Time
Action to Take
Bandwidth monitoring A syslog error message
and an SNMP trap is
generated when the
VLTi bandwidth usage
goes above the 80%
threshold and when it
drops below 80%. A syslog error message
and an SNMP trap is
generated when the
VLTi bandwidth usage
goes above its threshold. Depending on the traffic
that is received, the
traffic can be offloaded
inVLTi.
Domain ID mismatch The VLT peer does not
boot up. The VLTi is
forced to a down state.
A syslog error message
and an SNMP trap are
generated.
The VLT peer does not
boot up. The VLTi is
forced to a down state.
A syslog error message
and an SNMP trap are
generated.
Verify the domain ID
matches on both VLT
peers.
Dell Networking OS
Version mismatch A syslog error message
is generated. A syslog error message
is generated. Follow the correct
upgrade procedure for
the unit with the
mismatched Dell
Networking OS version.
Remote VLT port
channel status N/A N/A Use the show vlt
detail and show vlt
brief commands to
view the VLT port
channel status
information.
PMUX Mode of the IO Aggregator 247