Dell 2135cn Color Laser Printer - Manual (Page 55)

Draft Mode
Purpose:
To save toner by printing in the draft mode. The print quality is reduced when printing in the draft mode.
Values:
LineTermination
Purpose:
To add the line termination commands.
Values:
Default Color
Purpose:
To specify the color mode to Color or Black. This setting is used for a print job which does not specify a print mode.
Value:
Wired Network
Use the Wired Network menu to change the printer settings affecting jobs sent to the printer through the wired network.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the printer is turned off and then on again.
Values:
TCP/IP
Purpose:
Disable* Does not print in the draft mode.
Enable Prints in the draft mode.
Off*
The line termination command is not added.
CR=CR, LF=LF, FF=FF
Add-LF
The LF command is added.
CR=CR-LF, LF=LF, FF=FF
Add-CR
The CR command is added.
CR=CR, LF=CR-LF, FF=CR-FF
CR-XX
The CR and LF commands are added.
CR=CR-LF, LF=CR-LF, FF=CR-FF
Black* Prints in the black and white mode.
Color Prints in the color mode.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Auto* Detects the Ethernet settings automatically.
10Base Half Uses 10base-T half-duplex.
10Base Full Uses 10base-T full-duplex.
100Base Half Uses 100base-TX half-duplex.
100Base Full Uses 100base-TX full-duplex.