Dell 2135cn Color Laser Printer - Manual (Page 158)

Back to Contents Page
Installing Printer Drivers
Personal Printer Setup
Network Printer Setup
Troubleshooting Instructions
Personal Printer Setup
1. Insert the Drivers and Utilities CD into your computer to start Easy Setup Navigator.
2. Click Software Installation to launch the installation software.
3. Select Personal Installation (USB or Parallel), and then click Next.
4. Click Install.
5. Follow the instructions that appear on the Found New Hardware Wizard dialog box to install the printer driver on your computer.
6. When the Completing the Found New Hardware Wizard dialog box appears, click Finish.
7. Select either Typical Installation (recommended) or Custom Installation from the installation wizard, and then click Install. If you select Custom
Installation, you can select the specific software you want to install.
8. Click Finish to exit the wizard when the Congratulations! screen appears. If necessary, click Print Test Page to print a test page or FAX Initial Setup to
setup the fax on your printer.
USB Printing
A local printer is a printer attached to your computer or a print server using a USB. If your printer is attached to a network and not your computer, see
"Network Printer Setup" .
Network Printer Setup
Printing and Checking the System Settings Page
Before installing the printer driver on your computer, print the System Settings page to check your printer's IP address.
From the Printer Operator Panel
1. Press until >SETUP appears, and then press .
2. Press until >Reports appears, and then press .
3. System Settings is displayed. Press .
The System Settings page is printed.
4. Look under the TCP/IP heading on the System Settings page.
If the IP address is 0.0.0.0, wait for a few minutes to resolve the IP address automatically, and then print the System Settings page again.
From Your Computer
NOTE: If the CD does not automatically launch, click start® Run, and then type D:\setup_assist.exe (where D is the drive letter of your CD), and
then click OK.