Dell 2135cn Color Laser Printer - Manual (Page 24)

Printer Maintenance
The Printer Maintenance tab includes the System Settings, Clock Settings, Paper Density, Registration Adjustment, Adjust Altitude, Reset Defaults, Non-
Dell Toner, Initialize PrintMeter, Web Link Customization, TCP/IP Settings, Tray Settings, EWS, Scan Defaults, Fax Defaults, Copy Defaults, and Fax
Settings pages.
System Settings
Purpose:
To configure the printer's power management, auto clear time, alarm tones, time-out time, mm/inch setting, job log auto print, position of the Print ID, setting
of the dump print, setting of the additional memory, setting of the substitute sheet, and operator panel language settings.
Values:
Country Displays the country where the printer is used.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Power Saver
Timer Mode
Power Saver Timer
Mode 1*1
5-60 minutes
Specifies the time before the printer enters the power saver timer mode 1(sleep
mode) after it finishes a job.
5 minutes*
Power Saver Timer
Mode 2*1 1-6 minutes Specifies the time before the printer enters the power saver timer mode 2 (deep
sleep mode) after it finishes a job.
6 minutes*
Auto Reset
45 seconds*
Specifies the time before the printer automatically resets the settings on the
operator panel to the defaults when no additional settings are made.
1 minute
2 minutes
3 minutes
4 minutes
Alert Tone
Panel Select
Tone
Low
Emits a tone at the specified volume when the operator panel input is correct. Medium
High
Off* Does not emit a tone when the operator panel input is correct.
Panel Alert
Tone
Low
Emits a tone at the specified volume when the operator panel input is incorrect. Medium
High
Off* Does not emit a tone when the operator panel input is incorrect.
Machine Ready
Tone
Low
Emits a tone at the specified volume when the printer becomes ready. Medium*
High
Off Does not emit a tone when the printer becomes ready.
Copy Job Tone
Low
Emits a tone at the specified volume when copying is complete. Medium*
High
Off Does not emit a tone when copying is complete.
Non-Copy Job
Tone
Low
Emits a tone at the specified volume when any other job except copying is
complete.
Medium*
High
Off Does not emit a tone when any other job except copying is complete.
Fault Tone
Low
Emits a tone at the specified volume when a job ends abnormally. Medium*
High
Off Does not emit a tone when a job ends abnormally.
Alert Tone
Low
Emits a tone at the specified volume when a problem occurs. Medium*
High
Off Does not emit a tone when a problem occurs.
Out of Paper
Tone
Low
Emits a tone at the specified volume when the printer runs out of paper. Medium*
High
Off Does not emit a tone when the printer runs out of paper.
Low