beautypg.com

Motorola 3347 User Manual

Page 42

background image

42

Default Channel

(1 through 11, for Nor th America) on which the network will broadcast. This is a frequency
range within the 2.4Ghz band. Channel selection depends on government regulated radio
frequencies that var y from region to region. The widest range available is from 1 to 14.
Europe, France, Spain and Japan differ. Channel selection can have a significant impact on
per formance, depending on other wireless activity close to this Router. Channel selection
is not necessar y at the client computers; the clients will scan the available channels seek-
ing access points using the same SSID as the client.

AutoChannel Setting

For 802.11G models, AutoChannel is a feature that allows the Motorola Netopia® Gateway
to determine the best channel to broadcast automatically.

Three settings are available from the pull-down menu:

Off-Use default, At Startup, and

Continuous.

Off-Use default: the Motorola Netopia® Gateway will use the configured default chan-
nel selected from the previous pull-down menu.

At Startup – the default setting – causes the Motorola Netopia® Gateway at startup to
briefly initialize on the default channel, then per form a full two- to three-second scan,
and switch to the best channel it can find, remaining on that channel until the next
reboot.

Continuous per forms the at-startup scan, and will continuously monitor the current
channel for any other Access Point beacons. If an Access Point beacon is detected on
the same channel, the Motorola Netopia® Gateway will initiate a three- to four-minute
scan of the channels, locate a better one, and switch. Once it has switched, it will
remain on this channel for at least 30 minutes before switching again if another Access
Point is detected.

Enable Closed System Mode

If enabled, Closed System Mode hides the wireless network from the scanning features of
wireless client computers. Unless both the wireless clients and the Router share the same
Wireless ID in Closed System mode, the Router’s wireless LAN will not appear as an avail-
able network when scanned for by wireless-enabled computers. Members of the Closed
System WLAN must log onto the Router’s wireless network with the identical SSID as that
configured in the router.