Motorola 3347 - Manual (Page 218)

218
If you specify v2-MD5, you must also specify a rip-send-key. Keys are ASCII strings with a
maximum of 31 characters, and must match the other router(s) keys for proper operation
of MD5 suppor t.
set ip dsl vccn rip-receive
{ off | v1 | v2 | v1-compat | v2-MD5 }
Specifies whether the Motorola Netopia® Gateway should use Routing Information Protocol
(RIP) broadcasts to update its routing tables with information received from other routers.
If you specify v2-MD5, you must also specify a rip-receive-key. Keys are ASCII strings
with a maximum of 31 characters, and must match the other router(s) keys for proper oper-
ation of MD5 suppor t.
Ethernet LAN Settings
set ip ethernet A option { on | off }
Enables or disables communications through the designated Ethernet por t in the Gateway.
You must enable TCP/IP functions for an Ethernet por t before you can configure its network
settings.
set ip ethernet A address ip_address
Assigns an IP address to the Motorola Netopia® Gateway on the local area network. The IP
address you assign to the local Ethernet inter face must be unique on your network. By
default, the Motorola Netopia® Gateway uses 192.168.0.1 as its LAN IP address.
set ip ethernet A broadcast broadcast_address
Specifies the broadcast address for the local Ethernet inter face. IP hosts use the broad-
cast address to send messages to ever y host on your network simultaneously.
The broadcast address for most networks is the network number followed by 255. For
example, the broadcast address for the 192.168.1.0 network would be 192.168.1.255.