System settings – Motorola 3347 User Manual
Page 269
269
CONFIG Commands
show snmp v3 engine-id
Displays the router’s SNMP Engine ID. This is not editable.
System Settings
You can configure system settings to assign a name to your Motorola Netopia® Gateway
and to specify what types of messages you want the diagnostic log to record.
set system name
name
Specifies the name of your Motorola Netopia® Gateway. Each Motorola Netopia® Gateway
is assigned a name as par t of its factor y initialization. The default name for a Motorola
Netopia® Gateway consists of the word “Netopia-3000/XXX” where “XXX” is the serial
number of the device; for example, Netopia-3000/9437188. A system name can be 1 –
255 characters long. Once you have assigned a name to your Motorola Netopia® Gateway,
you can enter that name in the Address text field of your browser to open a connection to
your Motorola Netopia® Gateway.
☛
NOTE:
Some broadband cable-oriented Ser vice Providers use the
System Name as
an impor tant identification and suppor t parameter. If your Gateway is par t of
this type of network, do
NOT alter the System Name unless specifically
instructed by your Ser vice Provider.
set system diagnostic-level
{ off | low | medium | high | alerts | failures }
Specifies the types of log messages you want the Motorola Netopia® Gateway to record.
All messages with a level equal to or greater than the level you specify are recorded. For
example, if you specify set system diagnostic-level
medium, the diagnostic log will retain
medium-level informational messages, aler ts, and failure messages. Specifying
off turns
off logging.
Use the following guidelines:
•
low
- Low-level informational messages or greater; includes trivial status messages.