Motorola 3347 - Manual (Page 259)

259
CONFIG Commands
set security ipsec tunnels name "123" IKE-mode PFS-enable
{ off | on }
See page 94 for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode invalid-spi-recovery
{ off | on }
Enables the Gateway to re-establish the tunnel if either the Motorola Netopia® Gateway or
the peer gateway is rebooted.
set security ipsec tunnels name "123" xauth enable {off | on }
Enables or disables Xauth extensions to IPsec, when IKE-mode neg-method is set to
aggressive. Default is off.
set security ipsec tunnels name "123" xauth username username
Sets the Xauth username, if Xauth is enabled.
set security ipsec tunnels name "123" xauth password password
Sets the Xauth password, if Xauth is enabled.
set security ipsec tunnels name "123" nat-enable { on | off }
Enables or disables NAT on the specified IPsec tunnel. The default is off.
set security ipsec tunnels name "123" nat-pat-address ip-address
Specifies the NAT por t address translation IP address for the specified IPsec tunnel.
set security ipsec tunnels name "123" local-id-type
{ IP-address | Subnet | Hostname | ASCII }
Specifies the NAT local ID type for the specified IPsec tunnel, when Aggressive Mode is set.