beautypg.com

Dmt settings – Motorola 3347 User Manual

Page 207

background image

207

CONFIG Commands

DMT Settings

DSL Commands

set dmt dsl-annex-support [ off | on ]

This controls whether other annex suppor t (just as Annex M) is enabled. Default is

off.

set dmt type [ lite | dmt | ansi | multi | adsl2 | adsl2+ | readsl2 |
adsl2anxm | adsl2+anxm ]

Selects the type of Discrete Multitone (DMT) asynchronous digital subscriber line (ADSL)
protocol to use for the WAN inter face.

The

type value also supports the following settings on certain model units: adsl2, adsl2+,

readsl2, adsl2anxm, adsl2+anxm.

NOTE:

Some

dmt type settings are now supported for many Annex B (335xN) plat-

forms. 2200 Series and 33xxN Series models are suppor ted. Currently,
adsl2anxm and adsl2+anxm are not supported in Annex B.

set dmt autoConfig [ off | on ]

Enables suppor t for automatic VPI/VCI detection and configuration. When set to

on (the

default), a pre-defined list of VPI/VCI pairs are searched to find a valid configuration for
your ADSL line. Entering a value for the VPI or VCI setting will disable this feature.

set dmt dmt dying-gasp [ default | off | on ]

Enables or disables Gateway “dying gasp” behavior in cases of power failure. Default is
off.

set dmt wiringMode [ auto | tip_ring | A_A1 ]

(not suppor ted on all models) This command configures the wiring mode setting for your
ADSL line. Selecting

auto (the default) causes the Gateway to detect which pair of wires