Snmp settings – Motorola 3347 User Manual
Page 265
265
CONFIG Commands
SNMP Settings
The Simple Network Management Protocol (SNMP) lets a network administrator monitor
problems on a network by retrieving settings on remote network devices. The network
administrator typically runs an SNMP management station program on a local host to
obtain information from an SNMP agent such as the Motorola Netopia® Gateway.
set snmp community read
name
Adds the specified name to the list of communities associated with the Motorola Netopia®
Gateway. By default, the Motorola Netopia® Gateway is associated with the public commu-
nity.
set snmp community write
name
Adds the specified name to the list of communities associated with the Motorola Netopia®
Gateway.
set snmp community trap
name
Adds the specified name to the list of communities associated with the Motorola Netopia®
Gateway.
set snmp trap ip-traps
ip-address
Identifies the destination for SNMP trap messages. The
ip-address
argument is the IP
address of the host acting as an SNMP console.
set snmp sysgroup contact
contact_info
Identifies the system contact, such as the name, phone number, beeper number, or email
address of the person responsible for the Motorola Netopia® Gateway. You can enter up to
255 characters for the
contact_info
argument. You must put the
contact_info
argu-
ment in double-quotes if it contains embedded spaces.
set snmp sysgroup location
location_info
Identifies the location, such as the building, floor, or room number, of the Motorola Neto-
pia® Gateway. You can enter up to 255 characters for the
location_info
argument.