Motorola 3347 User Manual
Page 289
289
CONFIG Commands
set vlan name
name
ports
port
tag [ off | on ]
If set to
on, packets transmitted from this port through this VLAN must be tagged with the
VLAN VID. Packets received through this por t destined for this VLAN must be tagged with
the VLAN VID by the source. The
tag option is only available on global type ports.
set vlan name
name
ports
port
priority [ off | on ]
Enables or disables the
priority for the port assigned to the specified VLAN allowing
packet prioritization based on any 802.1p priority bits in the VLAN header to prioritize pack-
ets within the Gateway’s internal queues, according to DiffSer v priority mapping rules.
set vlan name
name
ports
port
promote [ off | on ]
Enables or disables the
promote setting allowing writing any 802.1p priority bits into the
IP-TOS header bit field for received IP packets on this por t destined for this VLAN. Write any
IP-TOS priority bits into the 802.1p priority bit field for tagged IP packets transmitted from
this por t for this VLAN. All mappings between Ethernet 802.1p and IP-TOS are made via
diffserv dscp-map settings.
set vlan name
name
ports
port
port-pbits [ 0 - 7 ]
Specifies the 802.1p priority bit for this por t associated with the specified VLAN. If you set
this to a value greater than 0, all packets of this por t with unmarked priority bits (pbits) will
be re-marked to this priority.
set vlan name
name
ip-interface
ip_interface
Associates this VLAN with the specified IP inter face. By default the
ip-vcc1 and ip-eth-a
inter faces are available, but others may be defined.
set vlan name
name
inter-vlan-routing [ group-1... group-8 ] [ off | on ]
When set to
on, inter-vlan-routing allows VLANs in the specified group to route traffic to
the others; ungrouped VLANs cannot route traffic to each other.
You must save the changes, exit out of configuration mode, and restar t the Gateway for the
changes to take effect.