Motorola 3347 - Manual (Page 266)

266
You must put the location_info argument in double-quotes if it contains embedded
spaces.
SNMP Notify Type Settings
set snmp notify type [ v1-trap | v2-trap | inform ]
Sets the type of SNMP notifications that the system will generate:
• v1-trap – This selection will generate notifications containing an SNMPv1 Trap Protocol
Data Unit (PDU)
• v2-trap – This selection will generate notifications containing an SNMPv2 Trap PDU
• inform – This selection will generate notifications containing an SNMPv2 InformRe-
quest PDU.
SNMP V3 Settings
SNMP V3 is suppor ted beginning with Firmware Version 7.4.
SNMPv3 suppor ts two users, the Read-Only user and the Read-Write user. The read-only
account will have read-only access to all objects known to the agent, while the read-write
account will have read-write access to all objects known to the agent. SNMPv3 adds the
ability to authenticate and/or encr ypt management traffic.
For security reasons, enabling SNMPv3 will disable SNMPv1/v2.
• If SNMPv3 is enabled, the firmware will no longer respond to SNMPv1/SNMPv2 traffic,
nor generate SNMPv1/v2 traps in SNMPv1/SNMPv2 packets. If it receives v1 or v2
packets when v3 is enabled, it behaves as if it does not suppor t v1/v2, and silently dis-
cards the incoming packet.
• If SNMPv3 is disabled, the firmware will not respond to SNMPv3 traffic, nor generate
SNMPv3 notifications. The firmware behaves as if it does not suppor t v3 and silently
discards the incoming packet.
set snmp v3 enable [ off | on ]
Turns SNMPv3 off or on.