beautypg.com

Pppoe /pppoa settings – Motorola 3347 User Manual

Page 242

background image

242

set pinhole name name internal-port [ 0 - 65535 ]

Specifies the por t number your Motorola Netopia® Gateway should use when for warding
traffic of the specified type. Under most circumstances, you would use the same number
for the external and internal por t.

PPPoE /PPPoA Settings

You can use the following commands to configure basic settings, por t authentication set-
tings, and peer authentication settings for PPP inter faces on your Motorola Netopia® Gate-
way.

Configuring Basic PPP Settings.

NOTE:

For the DSL platform you must identify the vir tual PPP inter face [

vccn], a num-

ber from 1 to 8.

set ppp module [vccn] option { on | off }

Enables or disables PPP on the Motorola Netopia® Gateway.

set ppp module [vccn] auto-connect { on | off }

Suppor ts manual mode required for some vendors. The default

on is not normally

changed. If auto-connect is disabled (

off), you must manually start/stop a ppp connection.

set ppp module [vccn] mru

integer

Specifies the Maximum Receive Unit (MRU) for the PPP inter face. The

integer

argument

can be any number between 128 and 1492 for PPPoE; 1500 other wise.

set ppp module [vccn] magic-number { on | off }

Enables or disables LCP magic number negotiation.