Domain name system settings – Motorola 3347 User Manual
Page 208
208
(inner or outer pair) are in use on your phone line. Specifying
tip_ring forces the inner pair
to be used; and
A_A1 the outer pair.
set dmt metallic-termination [ auto | disabled | always_on ]
(not suppor ted on all models) This command allows you to apply a sealing current to “dr y”
DSL lines so that the wiring doesn’t corrode.
•
auto - The device will scan for standard telephone service (POTS). If it finds POTS, it dis-
ables metallic termination. If it does not find POTS during the search period, then metal-
lic termination is enabled.
•
disabled - There is no POTS detection, and metallic termination is disabled.
•
always_on - The device will scan for POTS for information only. Metallic termination is
always enabled.
Domain Name System Settings
Domain Name System (DNS) is an information ser vice for TCP/IP networks that uses a
hierarchical naming system to identify network domains and the hosts associated with
them. You can identify a primar y DNS ser ver and one secondar y ser ver.
Common Commands
set dns domain-name
domain-name
Specifies the default domain name for your network. When an application needs to resolve
a host name, it appends the default domain name to the host name and asks the DNS
ser ver if it has an address for the “fully qualified host name.”
set dns primary-address
ip_address
Specifies the IP address of the primar y DNS name ser ver.
set dns proxy-enable
This allows you to disable the default behavior of acting as a DNS proxy. The default is
on.