beautypg.com

Motorola 3347 User Manual

Page 102

background image

102

SA Hash Type

SA Hash Type refers to the Authentication Hash algorithm used during SA
negotiation. Values suppor ted include MD5 and SHA1. N/A will display if
NONE is chosen for Auth Protocol.

Invalid SPI
Recovery

Enabling this allows the Gateway to re-establish the tunnel if either the
Netopia Gateway or the peer gateway is rebooted.

Soft MBytes

Setting the Soft MBytes parameter forces the renegotiation of the IPSec
Security Associations (SAs) at the configured Soft MByte value. The value
can be configured between 1 and 1,000,000 MB and refers to data traffic
passed. If this value is not achieved, the Hard MBytes parameter is
enforced. This parameter does not need to match the peer gateway.

Soft Seconds

Setting the Soft Seconds parameter forces the renegotiation of the IPSec
Security Associations (SAs) at the configured Soft Seconds value. The
value can be configured between 60 and 1,000,000 seconds. This param-
eter does not need to match the peer gateway.

Hard MBytes

Setting the Hard MBytes parameter forces the renegotiation of the IPSec
Security Associations (SAs) at the configured Hard MByte value.

The value can be configured between 1 and 1,000,000 MB and refers to
data traffic passed. This parameter does not need to match the peer gate-
way.

Hard Seconds

Setting the Hard Seconds parameter forces the renegotiation of the IPSec
Security Associations (SAs) at the configured Hard Seconds value. The
value can be configured between 60 and 1,000,000 seconds This parame-
ter does not need to match the peer gateway.

IPSec MTU

Some ISPs require a setting of e.g. 1492 (or other value). The default
1500 is the most common and you usually don’t need to change this
unless other wise instructed. Accepted values are from 100 – 1500.

This is the star ting value that is used for the MTU when the IPSec tunnel is
installed. It specifies the maximum IP packet length for the encapsulated
AH or ESP packets sent by the router. The MTU used on the IPSec connec-
tion will be automatically adjusted based on the MTU value in any received
ICMP can't fragment error messages that correspond to IPSec traffic initi-
ated from the router. Normally the MTU only requires manual configuration
if the ICMP error messages are blocked or other wise not received by the
router.

Table 3: IPSec Tunnel Details page parameters