Motorola 3347 - Manual (Page 100)

100
Parameter Descriptions
The following tables describe SafeHarbour’s parameters that are used for an IPSec VPN
tunnel configuration:
Table 2: IPSec Configuration page parameters
Field Description
Name The Name parameter refers to the name of the configured tunnel. This is
mainly used as an identifier for the administrator. The Name parameter is
an ASCII value and is limited to 31 characters. The tunnel name does not
need to match the peer gateway.
Peer External IP
Address The Peer External IP Address is the public, or routable IP address of the
remote gateway or VPN ser ver you are establishing the tunnel with.
Encryption
Protocol Encr yption protocol for the tunnel session.
Parameter values suppor ted include NONE or ESP.
Authentication
Protocol Authentication Protocol for IP packet header. The three parameter values
are None, Encapsulating Security Payload (ESP) and Authentication Header
(AH)
Key Management The Key Management algorithm manages the exchange of security keys in
the IPSec protocol architecture. SafeHarbour suppor ts the standard Inter-
net Key Exchange (IKE)
Table 3: IPSec Tunnel Details page parameters
Field Description
Name The Name parameter refers to the name of the configured tunnel. This is
mainly used as an identifier for the administrator. The Name parameter is
an ASCII value and is limited to 31 characters. The tunnel name does not
need to match the peer gateway.
Peer Internal
Network The Peer Internal IP Network is the private, or Local Area Network (LAN)
address of the remote gateway or VPN Ser ver you are communicating with.
Peer Internal
Netmask The Peer Internal IP Netmask is the subnet mask of the Peer Internal IP
Network.
NAT enable Turns NAT on or off for this tunnel.