About config commands, Config mode prompt, Navigating the config hierarchy – Motorola 3347 User Manual
Page 187
187
About CONFIG Commands
show ppp [{ stats | lcp | ipcp }]
Displays information about open PPP links. You can display a subset of the PPP statistics
by including an optional
stats
,
lcp
, or
ipcp
argument for the
show ppp
command.
start ppp vccn
Opens a PPP link on the specified vir tual circuit.
About CONFIG Commands
You reach the configuration mode of the command line inter face by typing
configure
(or
any truncation of
configure
, such as
con
or
config
) at the CLI SHELL prompt.
CONFIG Mode Prompt
When you are in CONFIG mode, the CLI prompt consists of the name of the Motorola Neto-
pia® Gateway followed by your current
node in the hierarchy and two right angle brackets
(>>). For example, when you enter CONFIG mode (by typing
config
at the SHELL prompt),
the
Netopia-3000/9437188 (top)>>
prompt reminds you that you are at the top
of the CONFIG hierarchy. If you move to the
ip
node in the CONFIG hierarchy (by typing
ip
at the CONFIG prompt), the prompt changes to
Netopia-3000/9437188 (ip)>>
to
identify your current location.
Some CLI commands are not available until cer tain conditions are met. For example, you
must enable IP for an inter face before you can enter IP settings for that inter face.
Navigating the CONFIG Hierarchy
•
Moving from CONFIG to SHELL — You can navigate from anywhere in the CONFIG
hierarchy back to the SHELL level by entering
quit
at the CONFIG prompt and pressing
R
ETURN
.
Netopia-3000/9437188 (top)>> quit
Netopia-3000/9437188 >
•
Moving from
top
to a subnode — You can navigate from the top node to a subnode
by entering the node name (or the significant letters of the node name) at the CONFIG