Motorola 3347 - Manual (Page 197)

197
CONFIG Commands
☛
NOTE:
A filterset can only be configured for the bridge if the system bridge or concur-
rent bridging/routing is enabled.
set bridge ethernet option { on | off }
Enables or disables bridging ser vices for the specified vir tual circuit using Ethernet fram-
ing.
set bridge dsl vcc n option { on | off }
Enables or disables bridging ser vices for the specified inter face. Specified inter face must
be par t of a VLAN if bridge is turned
on. Only RFC-1483 Bridged encapsulation is sup-
por ted currently.
• show log command will show that WAN Bridge is enabled when at least one WAN inter-
face is bridged.
• show ip interfaces and show bridge interfaces commands will show the inter faces
that are not in bridged mode and that are in bridged modes, respectively.
set bridge table-timeout [ 30 ... 6000 ]
Sets the timeout value for bridging table timeout. Default = 30 secs; range = 30 secs –
6000 secs (.5–100 mins).