Bridging settings – Motorola 3347 User Manual
Page 196
196
set atm [vccn] pppoe-sessions { 1 ... 8 }
Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The
total number of
pppoe-sessions and PPPoE VCCs configured must be less than or equal
to eight.
Bridging Settings
Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to
for ward non-TCP/IP traffic from one network to another. When bridging is enabled, the
Motorola Netopia® Gateway maintains a table of up to 512 MAC addresses. Entries that
are not used within 30 seconds are dropped. If the bridging table fills up, the oldest table
entries are dropped to make room for new entries.
Vir tual circuits that use IP framing cannot be bridged.
☛
NOTE:
For bridging in the 3341 (or any model with a USB por t), you cannot set the
bridge option off, or bridge ethernet option off; these are on by default
because of the USB por t.
Common Commands
set bridge sys-bridge {on | off }
Enables or disables bridging ser vices in the Motorola Netopia® Gateway. You must enable
bridging ser vices within the Motorola Netopia® Gateway before you can enable bridging for
a specific inter face.
set bridge concurrent-bridging-routing {on | off }
Enables or disables Concurrent Bridging/Routing.
set bridge dhcp-filterset "
string
"
Assigns a filterset named
string to the bridge configuration.