beautypg.com

Motorola 3347 User Manual

Page 225

background image

225

CONFIG Commands

Static ARP Settings

Your Motorola Netopia® Gateway maintains a dynamic Address Resolution Protocol (ARP)
table to map IP addresses to Ethernet (MAC) addresses. Your Motorola Netopia® Gateway
populates this ARP table dynamically, by retrieving IP address/MAC address pairs only
when it needs them. Optionally, you can define static ARP entries to map IP addresses to
their corresponding Ethernet MAC addresses. Unlike dynamic ARP table entries, static ARP
table entries do not time out.

You can configure as many as 16 static ARP table entries for a Motorola Netopia® Gate-
way. Use the following commands to add static ARP entries to the Motorola Netopia®
Gateway static ARP table:

set ip static-arp

ip-address

ip_address

Specifies the IP address for the static ARP entr y. Enter an IP address in the

ip_address

argument in dotted decimal format. The

ip_address

argument cannot be 0.0.0.0.

set ip static-arp

ip-address

ip_address

hardware-address

MAC_address

Specifies the Ethernet hardware address for the static ARP entr y. Enter an Ethernet hard-
ware address in the

MAC_address

argument in

nn.nn.nn.nn.nn.nn

(hexadecimal) for-

mat.

IGMP Forwarding

set ip igmp-forwarding [ off | on ]

Turns IP IGMP for warding off or on. The default is off.

IPsec Passthrough

set ip ipsec-passthrough [ off | on ]

Turns IPsec client passthrough off or on. The default is on.