beautypg.com

Motorola 3347 User Manual

Page 221

background image

221

CONFIG Commands

remote network. If you specify ppp, the Motorola Netopia® unit uses the default gateway
being used by the remote PPP peer.

IP-over-PPP Settings.

Use the following commands to configure settings for routing IP

over a vir tual PPP inter face.

NOTE:

For a DSL platform you must identify the vir tual PPP inter face [

vccn], a num-

ber from 1 to 8.

set ip ip-ppp [

vccn

] option { on | off }

Enables or disables IP routing through the vir tual PPP inter face. By default, IP routing is
turned on. If you turn off IP routing and save the new configuration, the Motorola Netopia®
Gateway clears IP routing settings

set ip ip-ppp [

vccn

] address

ip_address

Assigns an IP address to the vir tual PPP inter face. If you specify an IP address other than
0.0.0.0, your Motorola Netopia® Gateway will not negotiate its IP address with the remote
peer. If the remote peer does not accept the IP address specified in the

ip_address

argument as valid, the link will not come up.

The default value for the

ip_address

argument is 0.0.0.0, which indicates that the vir-

tual PPP inter face will use the IP address assigned to it by the remote peer. Note that the
remote peer must be configured to supply an IP address to your Motorola Netopia® Gate-
way if you enter 0.0.0.0 for the

ip_address

argument.

set ip ip-ppp [

vccn

] peer-address

ip_address

Specifies the IP address of the peer on the other end of the PPP link. If you specify an IP
address other than 0.0.0.0, your Motorola Netopia® Gateway will not negotiate the remote
peer's IP address. If the remote peer does not accept the address in the

ip_address

argument as its IP address (typically because it has been configured with another IP
address), the link will not come up.