Bio-Rad Bio-Plex Manager™ MP Software Upgrade - Manual (Page 114)

112 | Bio-Plex Manager MP Software
Index
Flat Bottom plate 27
Fluidics Preparation routine 80
Fluidics, checking status of 68
I
Instrument not connected error message 107
L
License activation, offline 91
License activation, online 89
License deactivation, offline 99
License deactivation, online 97
Lot numbers 66
Low bead count 36
Low Bead Count error 108
M
Maintenance of instrument, checking status of
68
Maintenance routine, failed 69
Maintenance routines, beginning of the day 59
Maintenance routines, daily 59
Maintenance routines, end of the day 59
Maintenance routines, interrupting 71
Maintenance routines, monitoring 62
Maintenance routines, running 60
Maintenance view 57
Most Concentrated Standard parameter 22
N
New From 23
Nonuse, preparing instrument for 71
P
PCR plate 27
Plate formatting 14
Plate heater, temperature range of 28
Plate heater, using 28
Plate types 27
Plate types, calculating probe height 27
Plates, formatting 14
Plates, guidelines for handling 26
Post-run routine 30
Prepare for Storage routine 81
Pre-run routine 29
Prime routine 82
Probe height, adjusting 72
Protocol dialog box 10
Protocol dialog, navigating to 10
Protocol run, interrupting 34
Protocol run, resuming 35
Protocol setup, overview of 9
Protocol, definition of 9
Protocols, editing 23
Protocols, reusing 23
Protocols, running 28
Protocols, running in Bio-Plex Manager 6.1 28
Protocols, saving 11
R
Raw data table, description 32
Reagent block, description of 64
Reagent block, setting up 64
Recommended routine 58
Recommended routine, running 25
Region Selection/Severe Clog error 107
Replicate groups, autofilling 18
Replicate groups, defining 18
Result name, default 40
Run results table, description 38
Run Settings dialog box 29
S
Saving protocols 11
Selecting analytes 13
Set Replicate Size 19
Shut Down routine 83
Shut Down, checking status of 68
Software activation, offline 91
Software activation, online 89