Banner PresencePLUS P4 EDGE 1.3 Series - Manual (Page 70)

Main Tasks to Complete Step 1
the Tool Configuration
dialog. 2. Select the Tools Configuration tab.
3. Scroll down to the Coordinate Tool, and then select the checkbox next to it, as
shown below.
4. Click the OK button to close the Tool Configuration dialog.
Main Tasks to Complete Step 2
Create a New
Inspection using
Setup.
1. In the PresencePLUS GUI, create a new inspection by pressing the Setup button
in the upper-left corner of the GUI.
2. Capture an image of the part to locate.
3. Press the Goto Tools button in the lower-right corner of the Setup tab.
Main Tasks to Complete Step 3
Add a Geometric
Find tool to locate
1. In the PresencePLUS GUI, click the Location Tools tab.
P/N 000000 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
70
7/2009 System Setup Window Overview