Rockwell Automation 2706-MB1 MESSAGEVIEW 421 SOFTWARE MANUAL User Manual
Page 299
![background image](/manuals/580630/299/background.png)
Global Configuration Parameters
F–2
Publication 2706-817
Parameter name
MessageBuilder
Software
MessageView
421 Terminals
(Default)
Range
Description
Return Msg Num
When a message is displayed, whether its
message number should be sent to the
controller
(No)
Yes
•
RIO Baud Rate
Setting up Remote I/O communications port
(57.6K)
115.2K, 230.4K
View Only
•
RIO Block Transfer
Whether block transfer (default) or discrete I/O
should be used
(Disabled)
Enabled
View Only
•
RIO Last Chassis
Is this the last chassis on the logic controller?
(No)
Yes
View Only
•
RIO Module
The starting module for MessageView
addresses
(0)
1 to 3
View Only
•
RIO Pass-Through
Whether the controller should pass
data/applications through to the computer on
another network
(Disabled)
Enabled
View Only
n/a
RIO Rack Number
Setting up Remote I/O communications port
(4
octal
)
0 to 3, 5 to 76
octal
View Only
•
RIO Rack Size
Setting up Remote I/O communications port
1
/
4
,
1
/
2
,
3
/
4
, Full
View Only
•
RS-232 Data Bits
Setting up the motherboard communications
port
(8)
7
•
•
RS-232 Hardware
Handshake
Setting up the motherboard communications
port
(Enable)
Disable
•
•
RS-232 Parity
Setting up the motherboard communications
port
(None)
Odd, Even
•
•
RS-232 Stop Bits
Setting up the motherboard communications
port
(1)
2
•
•
RS-232 Baud Rate
Setting up the motherboard communications
port
(19200)
300, 1200, 2400, 9600,
38,400
•
•
Send Values at Power-Up
Whether to send data to PLC following loss of
communications and at powerup;
RIO has this always enabled
(Disable)
Enable
•
•
Simulate Mode
Allow a demonstration using a MessageView
terminal not connected to a logic controller or
any devices
(Disable)
Enable
•
•
Startup Msg
The message to be displayed at powerup
(none)
1 to 9900
•
•
Trigger Priority
Whether a bit trigger or a value trigger has
higher priority
(bit)
value
•
Values at Power-Up
Send data type as Preset or as in the Last
active communications state
(Preset)
Last
•
•