Rockwell Automation 2706-MB1 MESSAGEVIEW 421 SOFTWARE MANUAL - Manual (Page 21)

2–4 Installing MessageBuilder Software
Publication 2706-817
15. The installation prompts you to update the AUTOEXEC.BAT
file. It adds:
– C:\AB\BIN to the path.
– C:\RSI\IC\BIN to the path.
– SHARE.EXE to the file (Windows 3.1x only).
– Environment variable ABIC_CONFIG=C:\RSI\IC\BIN.
– ABICRUN.BAT (starts INTERCHANGE software).
Important: MessageBuilder Configuration software and
INTERCHANGE Software will not run without these
lines.
Note: If you do not update your AUTOEXEC.BAT file during
MessageBuilder installation, MessageBuilder software writes the
changes to the file AUTOEXEC.EXM for future reference.
16. The INTERCHANGE Device Configuration Utility opens. Use
this utility to select and configure the “DF1 on COM Port”
communication drivers that your computer (workstation) will use
to transfer MessageView applications. See Page 2–8.
17. Review the release note that appears at the end of the installation
procedure.
18. When the installation is complete, you must exit Windows and
reboot your computer.