5 - install and replace components, Required tools, Chapter 5 – Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual User Manual
Page 107: Install and replace components, Chapter

Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
107
Chapter
5
Install and Replace Components
Required Tools
You need a #1 and #2 Phillips screwdriver to replace some of the components.
Topic
Page
Install or Replace the Logic Module
Install or Replace a Communication Module
Install the AC Power Supply Module
ATTENTION: Prevent Electrostatic Discharge
This equipment is sensitive to electrostatic discharge, which can cause internal
damage and affect normal operation.
Follow these guidelines when you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• Use a static-safe workstation, if available.
• Store the equipment in appropriate static-safe packaging when not in use.
SHOCK HAZARD: Disconnect power from the terminal before installing or
replacing any components. Failure to disconnect power can result in electrical
shock or damage to the terminal.