Rockwell Automation 1775-S5_SR5,D17756.5.5 User Manual PLC-3 FAMILY I/0 - Manual (Page 27)

Chapter
2
2-1
Configuring the Scanner through LIST
You use LIST function to configure the scanner. This chapter describes the
LIST selections. Read this chapter to learn how to:
access the LIST function
configure the front panel and channel 0 through scanner number 1
configure communication channels for I/O, backup, or
peer-to-peer communication
configure communication channel 4 for I/O, DH, or
DH+ communication
You can access the LIST function for the scanner through a programming
terminal or the data access panel on the PLC-3 or PLC-3/10 main chassis
(cat. nos. 1775-A1, -A3). Refer to the PLC-3 Family Programmable
Controller Installation and Operation Manual (publication 1775-6.7.1) for
detailed information on operating the LIST function.
Important: The scanner limits the number of executing LIST functions to
four for any PLC-3 or PLC-3/10 system.
Figure 2.1 shows you the parameters that you select for the scanner. You
access these selections by doing the following:
1. Enter LIST.
The system displays the initial LIST menu.
2. Select option 6 for MODULE STATUS.
3. Select the number corresponding to the scanner that you want to
configure.
The system displays the following menu:
1775-S5 1
CHASSIS 0 SLOT 3
1 CHANNEL 1
2 CHANNEL 2
3 CHANNEL 3
4 CHANNEL 4
5 RACK RANGE
6 CHAN 0
7 DISPLAY
ENTER NEXT >
Chapter Objectives
Accessing the LIST Function