Rockwell Automation 1760-xxxx Pico Controller User Manual - Manual (Page 145)

Publication 1760-UM001D-EN-P - September 2005
Pico System Settings 6-13
Deactivate RUN Mode
Select RUN MODE å from the menu and press Ok. The RUN MODE is
deactivated.
Behavior When the Circuit Diagram is Deleted
The setting for the start-up behavior is a Pico device function. When
the circuit diagram is deleted, this does not result in the loss of the
setting selected.
Behavior During Upload and Download
When a valid circuit diagram is transferred from Pico to a memory
module or the PC or vice versa, the setting is still retained.
Pico
controllers without a display can only be started in Run mode.
Possible Faults
Pico will not start in Run mode if:
1. Pico does not contain a circuit diagram.
2. You have put Pico in Stop mode (Run Mode menu displayed).
Card Startup Behavior
The startup behavior with memory module is for applications where
unskilled personnel change the memory module under no-voltage
conditions.
Start-Up Behavior Menu Displayed Status of Pico After Start-Up
Pico begins in Stop mode RUN MODE Pico is in Stop mode
Pico begins in Run mode RUN MODE å Pico is in Run mode
DEBOUNCE
P BUTTONS
RUN MODE
CARD MODE