Rockwell Automation 1760-xxxx Pico Controller User Manual User Manual

Pico controllers

Table of contents

Document Outline

1760-UM001D-EN-P, Pico Controllers User Manual
- Important User Information
Summary of Changes
- Catalog Number Release History
- New Information
Table of Contents
Preface
- Who Should Use this Manual
- Purpose of this Manual
- Common Techniques Used in this Manual
- Rockwell Automation Support
1 - System Overview
- Overview
- Hardware Versions
- Operating Principles
2 - Installation
- Prevent Electrical Shock
- European Communities (EC) Directive Compliance
- Connect the Expansion Module
- Mount the Pico Controller
- Install the Remote Processor
- Wire Terminals
- Connect the Incoming Power
- Use Surge Suppressors
- Connect the Inputs
- Connect Outputs
- Connect Relay Outputs
- Connect Transistor Outputs
3 - Commission the Pico
- Power On Unit
- Set the Menu Language
- Modes of Operation
- Create a Circuit Diagram (Program)
4 - Draw a Circuit Diagram with Pico
- Pico Operation
- Work with Contacts and Relays
- Function Relay Types
- Example with Timing and Counter Relays
- Timing Relays
- Counter Relays
- High Speed Counters
- Time Switch
- Analog Comparators
- Text Display
- Jumps
- Example Programs
5 - Save and Load Circuit Diagrams
- Interface to Memory Module and Programming Cable
- Memory Module
- PicoSoft
6 - Pico System Settings
- Password Protection
- Change the Menu Language
- Change Parameters
- Set Date, Time, and Daylight Saving Time
- Change Between Winter/ Summer Time (Daylight Saving Time)
- Activate Debounce (Input Delay)
- Activate and Deactivate P-Buttons
- Start-Up Behavior
- Set Cycle Time
- Retention
- Display Device Information
7 - Retention
- What is Retention?
- Set Retention
- Delete Retentive Actual Values
- Transfer Retentive Behavior
- Retentive Auxiliary Relays (Markers)
- Retentive Timing Relays
- Retentive Up/Down Counters C7 and C8
8 - Inside Pico
- Circuit Diagram Cycle
- Determine Cycle Time of Circuit Diagrams
- Delay Times for Inputs and Outputs
9 - Use of Expansion Modules
- Overview
- Operation
- Module Status Example
10 - Troubleshoot Your Controller
- Messages from the Pico System
- Possible Situations When Creating Circuit Diagrams
- Event
11 - DC Simulator
- Description
- Installation Guidelines
A - Specifications
- Physical Specifications
- Environmental Specifications
- Electrical Specifications
- Power Supply
- Inputs
- Outputs
- Cycle Time
- Dimensions
B - Circuit Diagram Form
Glossary
Index
Back Cover