Rockwell Automation 1203-GK5 DeviceNet Communications Module FRN 1.xxx-3.xxx - Manual (Page 19)

Overview 1-7
1336-GM5 Board
When unpacking the 1336-GM5 board, ensure that the contents of the
shipping box include:
• 1336-GM5 DeviceNet Communications Board.
• One 5-pin plug-in connector.
• One grounding wrist strap.
• Four Phillips mounting screws.
• Four stand-off nylon headers.
• One snap-in communications housing with mounting
instructions.
• DeviceNet Communications Module User Manual.
To install and configure a 1336-GM5 board, ensure that you have the
following tools and equipment:
• #1 Phillips screwdriver.
• Appropriate cable for the DeviceNet connection. Refer to the
“Selecting Cables” section in Chapter 3, Installing the 1203-GK5
Module or 1336-GM5 Board.
• A computer that is:
– Running DeviceNet Manager or RSNetWorx for DeviceNet.
– Connected to and communicating with the DeviceNet
network using an available computer to DeviceNet interface
such as a 1784-PCD card or a 1770-KFD adapter.
– Able to connect to a PLC or SLC.
– Running RSLinx.
– Running RSLogix5 (if using PLC) or RSLogix500 (if using
SLC).
Important: Refer to http://www.software.rockwell.com for more
information on these software products.