Rockwell Automation 160 DEVICENET (DN1) MODULE FRN 1-2.XX - Manual (Page 17)

Publication 0160-5.5 - September 1997
3-2 Installation and Wiring
EMC Directive 89/336/EEC
Compliance This product complies with Electromagnetic Compatibility (EMC)
Directive 89/336/EEC when conforming with the following installa-
tion requirements:
• The essential requirements for a conforming EMC installation for
the Bulletin 160 SSC are employed. Refer to the Bulletin 160 SSC
User Manual.
• The DeviceNet cable shield shall be connected to the SSC’s pro-
tective earth terminal, PE, with a low impedance connection.
• A clamp-on ferrite cable clamp (see Figure 3.6) shall be installed
on the DeviceNet communication cable within 10 cm (4 in.) of
the SSC. When multiple SSC’s are contained in one control cabi-
net, it is sufficient to install one clamp-on ferrite cable clamp
where the DeviceNet communication cable enters the control cab-
inet.
Low Voltage Directive 73/23/EEC
Compliance This product complies with Low Voltage Directive 73/23/EEC when
conforming with the following installation requirements:
• The essential requirements for a conforming Low Voltage Direc-
tive installation for the Bulletin 160 SSC are employed. Refer to
the Bulletin 160 SSC User Manual.
• Review “Safety Precautions” on page P-3 and P-4 in the Preface,
and other ATTENTION statements throughout this manual prior
to installation of the module.