Yamato Scientific HC200 Cool Block - Manual (Page 48)

46
Indication after Step/Step Procedure Explanation
Editing Segment 3
6. Push the ENTER key
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ The displays show that the ramp time of Segment 3
is set for the step operation.
7. Push either the ▼ key or the ▲ key.
(Ex. inputting 2 hours)
•
Push either the ▼ key or the ▲ key to set your desired
time.
⇒ ⇒ ⇒ ⇒ This setting changes Segment 3 from the step
operation to the ramp operation.
8. Push the ENTER key.
(Ex., inputting 37 ℃)
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key accepts the edited ramp
time of Segment 3.
⇒ ⇒ ⇒ ⇒ Left indication requests for input of the ramp level.
As you do not need to edit the ramp level of Segment
3, push the ENTER key to accept the existing value.
9. Push the ENTER key.
(Ex. inputting 0 minute 0 second)
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key accepts the existing ramp
level of Segment 3.
⇒ ⇒ ⇒ ⇒ The example on the left requests for the input of the
soak time. As you do not need to edit the soak time
of segment 3, push the ENTER key to accept the
existing value.
10. Push the ENTER key.
(Ex., turning OFF the wait function)
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key accepts the existing soak
time of Segment 3.
⇒ ⇒ ⇒ ⇒ Left indication requests for turning on or off the wait
function. As you do not need to turn on the function,
push the ENTER key to accept the existing status.
11.
Leave the displays for more than 1 minute . . .
The displays return to the screens shown just before
you have pushed the MODE key.
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key accepts the set wait
function of Segment 3.
⇒ ⇒ ⇒ ⇒ When you finish editing a segment, the controller
returns to the program edit mode. If you leave the
controller for more than 1 minute, the displays return
to the screens shown just before you have pushed
the MODE key.
(Ramp time of segment 3)
(Ex, 0 unused segments)
(Ex. 5 used segments)