Yamato Scientific HC200 Cool Block - Manual (Page 16)

14
Indication after Step/Step Procedure Explanation
7. Switching the sub display information.
Push the MENU MENU MENU MENU key to set the sub display
screen switching mode.
•
Switched to the latest measured temperature.
•
Switched to the ongoing program.
•
Switched to the remaining time.
⇒ ⇒ ⇒ ⇒ When the start time is up, the STANDBY lamp goes
out and HC200 starts the program operation.
⇒ ⇒ ⇒ ⇒ When the start time is up, the sub display shows the
latest parameters.
Ex: In the example shown on the left, HC200 is on the
first segment of Program 2, and the remaining
time of the segment is 10 seconds.
(During the program operation.)
! On the sub display screen switching mode, you can
check 3 pieces of information; the remaining time
before the ongoing segment finishes, the preset
temperature, and the ongoing program number.
See “Changing Sub Display Screens” on page 22.
8. When the program operation finishes
⇒ ⇒ ⇒ ⇒ HC200 stops regulating the temperature.
⇒ ⇒ ⇒ ⇒ The main display shows the latest measured
temperature.
⇒ ⇒ ⇒ ⇒ The sub display flashes the word .
⇒ ⇒ ⇒ ⇒ The HEAT lamp goes out.
⇒ ⇒ ⇒ ⇒ The PROGRAM lamp stays lit.
(Preset temperature in use)
(Program number in use)
(Segment number on process)
(Remaining time of the
ongoing segment)