Yamato Scientific HC200 Cool Block User Manual

Page 40

Contents of a Segment

Contents of a Repeat Command

•

Composition of a Repeat Command

With the repeat command, you can repeat a series of segments as many times as you like. This command is
composed of repeat start segment and repeat frequency.

1. Repeat Start Segment

In the segment input mode, input the segment number from which you want to repeat the cycle. The controller
repeats the cycle from your desired start segment to the segment immediately before the repeat start segment.
(See example below for inputting the repeat command.)

Example of the segment input mode.

Push either the ▼ key or ▲key

Example of the repeat command input mode.

Push the ENTER key.

Example of the repeat start segment number setting mode.

After selecting by the ▼ key or ▲key, push the ENTER key.

Example of the repeat frequency setting mode.

After selecting by the ▼ key or ▲key, push the ENTER key.

3. Repeat Frequency

You can set any frequency in a range from 1 to 999 cycles. If you want to continue the repeat operation
indefinitely, set the repeat frequency at 0 (zero). If this is the case, the controller closes the program input
mode.

! You cannot repeat the segments that you have set after inputting the repeat command.
! You cannot set a repeat command within the repeat block or link repeat commands.