Yamato Scientific HC200 Cool Block - Manual (Page 21)

19
Changing from Program Operation to Other Program Operation
You can change the operation program number, and can set the operation start time during the
program operation.
Indication after Step/Step Procedure Explanation
1. Push either the ▼ key or ▲ key.
•
Push either the ▼ key or ▲ key during the program
operation.
⇒ ⇒ ⇒ ⇒ The main display flashes the ongoing program
number.
⇒ ⇒ ⇒ ⇒ The sub display shows .
Ex. In the example on the left, the main display shows
ongoing program 2.
2. Push either the ▼ key or ▲ key.
⇒ ⇒ ⇒ ⇒ If an operational program is in the plural, the main
display flashes an operational program number to
reel an order.
•
Push either the ▼ key or the ▲ key to show your
desired program number.
! If you want to edit only the operation start time,
skip this step.
3. Push the ENTER key.
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key stops the ongoing program
operation.
⇒ ⇒ ⇒ ⇒ The STANDBY lamp lights.
⇒ ⇒ ⇒ ⇒ The main display flashes indicating the
operation start time setting mode.
4. Ex., starting operation in 2 hours and 30
minutes
Push either the ▼ key or ▲ key.
•
Push either the ▼ key or the ▲ key to set your desired
operation start time.
5. Push the ENTER key.
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ The main display shows the latest measured
temperature.
⇒ ⇒ ⇒ ⇒ The sub display shows the remaining time before
operation start.
⇒ ⇒ ⇒ ⇒ The STANDBY lamp starts flashing, indicating that
HC200 is ready for operation.
⇒ ⇒ ⇒ ⇒ The PROGRAM lamp goes from flashing to steady
lit.