Yamato Scientific HC200 Cool Block - Manual (Page 14)

12
Program Operation
Start up
After setting up HC200, follow the procedure described below to start operation.
Indication after Step/Step Procedure Explanation
1. Turn ON the power switch provided on the
front of HC200.
⇒ ⇒ ⇒ ⇒ When you turn on the power switch, HC200
automatically selects the fixed temperature operation
mode. The main display shows the present preset
temperature, while the sub display shows the
previously preset temperature.
⇒ ⇒ ⇒ ⇒ The STANDBY lamp lights up.
⇒ ⇒ ⇒ ⇒ The FIXED TEMP lamp starts flashing.
2. Ex., loading Program 2 for operation.
Push the MENU key.
⇒ ⇒ ⇒ ⇒ The main display flashes (Ex. Program 1).
⇒ ⇒ ⇒ ⇒ The sub display shows .
⇒ ⇒ ⇒ ⇒ The FIXED-TEMP lamp goes out.
⇒ ⇒ ⇒ ⇒ The PROGRAM lamp starts flashing.
⇒ ⇒ ⇒ ⇒ If there is no program registered, the main display
flashes
! See on “How to Compose a Program” page 35 for
composing a new
program.
3. Push either the ▼ key or the ▲key.
•
Push either the ▼ key or the ▲key until the program
number on the main display reaches your desired
program. (Ex. Program 2)
Ex. Measured
temperature: 25℃
Ex. set temperature:
37
℃