Yamato Scientific HC200 Cool Block - Manual (Page 23)

21
6. Program inputting and editing function
Push either the▼ key or the ▲key.
•
Push either the ▼ key or the ▲ key several times.
⇒ ⇒ ⇒ ⇒ The controller displays the program input/edit mode.
See “How to Compose a Program” on page 35.
⇒ ⇒ ⇒ ⇒ If there is no program registered, the main display
flashes.
⇒ ⇒ ⇒ ⇒ When more than one program has been registered,
the sub display shows the number of those
operational programs.
7. Program deleting function(Loading is limited.)
Push either the▼ key or the ▲key.
•
Push either the ▼ key or the ▲ key several times.
⇒ ⇒ ⇒ ⇒ The controller displays the program delete mode.
See “Deleting a Program” on page 47.
! The function works only when more than one
program has been registered. If there is no
program registered, the sub display is blank, and
the controller proceeds to the next function
selection mode.
8. Temperature holding function
(Loading is limited.)
Push either the▼ key or the ▲key.
•
Push either the ▼ key or the ▲ key several times.
⇒ ⇒ ⇒ ⇒ The controller displays the temperature holding
selection mode.
See “Setting and releasing the Temperature Holding
Function” on page 25.
! With this function, you can hold the temperature
measured at the time of setting. This function can
work only during the quick auto-stop operation or
the program operation, and when HC200 is ready
for the program operation. In other operation
modes, the controller proceeds to the next function
selection mode.
9. Resume function
Push either the▼ key or the ▲key.
•
Push either the ▼ key or the ▲ key several times.
⇒ ⇒ ⇒ ⇒ The controller displays the resume function selection
mode.
See “Resume Function” on page 31.
10. Escape function
Push either the▼ key or the ▲key.
•
Push either the ▼ key or the ▲ key several times.
⇒ ⇒ ⇒ ⇒ The controller displays the escape function selection
mode.
! “Escape” means to cancel the selected function or to
repeat inputting or editing a program from the
beginning before pushing the ENTER ENTER ENTER ENTER key.
See “The Escape Function” on page 26.
11. Abort function
Push either the▼ key or the ▲key.
•
Push either the ▼ key or the ▲ key several times.
⇒ ⇒ ⇒ ⇒ The controller display the abort function selection
mode.
! This function is for putting the ongoing fixed
temperature operation or quick auto-stop operation
or program operation to a stop, and changing to the
standby condition that no operation is selected.
See “The Abort (Forced Stop) Function” on page 27.
No program
available Program available
(Ex. 2programs)
(Ex. 2programs available)
Holding
function OFF Holding
function ON
Resume
function OFF Resume
function ON
or
or
or