Yamato Scientific HC200 Cool Block - Manual (Page 19)

17
Changing the Program Operation during Fixed Temperature Operation
(Ex. switching to Program 1 during the fixed temperature operation)
Indication after Step/Step Procedure Explanation
1. Push the MENU key.
(When starts flashing, push either ▼key or
▲key.)
(Ex. Loading Program 1)
•
Push the MENU key twice during the fixed
temperature operation.
⇒ ⇒ ⇒ ⇒ The main display flashes either operational program
number or (auto-stop).
Ex: In the example on the left, (Program 1)
flashes on the display.
•
If the display flashes , push either the ▼key or
the ▲key to show your desired program number.
⇒ ⇒ ⇒ ⇒ The PROGRAM lamp starts flashing.
⇒ ⇒ ⇒ ⇒ Since the fixed temperature operation is going on,
the HEAT lamp keeps flashing, which indicates that
HC200 is under temperature regulation.
2. Push the ENTER key.
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ The main display flashes indicating the
operation start time setting mode.
⇒ ⇒ ⇒ ⇒ The sub display flashes
3. Ex., finishing operation after 2 hours and 30
minutes
Push either the ▼ key or the ▲ key.
•
Push either the ▼key or the ▲key and set your desired
time before operation start.
4. Push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key changes the operation
mode from the fixed temperature operation to the
program operation.
⇒ ⇒ ⇒ ⇒ The main display shows the latest measured
temperature.
⇒ ⇒ ⇒ ⇒ The sub display shows the remaining time before
operation start.
⇒ ⇒ ⇒ ⇒ The STANDBY lamp starts flashing, indicating that
HC200 is ready for operation.
⇒ ⇒ ⇒ ⇒ The PROGRAM lamp goes from flashing to steady
lit.
5. Starting the program operation.
⇒ ⇒ ⇒ ⇒ When the set time is up, the STANDBY lamp goes
out and HC200 starts the program operation.
⇒ ⇒ ⇒ ⇒ The sub display shows the latest parameters. See
“Changing Sub Display Screens” on page. 22.
(Ex. Preset desired temperature
in use)