Yamato Scientific HC200 Cool Block - Manual (Page 27)

25
Setting and releasing the Temperature Holding Function
Indication after Step/Step Procedure Explanation
1. Select “Hold function” selection mode
Select the corresponding function. See “ Menu
Functions ” on page 21.
•
Select “Hold Function” selection mode by pressing the
MODE key.
⇒ ⇒ ⇒ ⇒ The sub display shows the present status of the hold
function: when the function has been released, it
shows and when the function has been set,
it shows .
2. Push the ENTER key
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ The controller turns to the hold function ON/OFF
mode.
⇒ ⇒ ⇒ ⇒ The sub display shows
3. Push either the ▼ key or the ▲ key.
•
Set the main display at ON for setting and OFF for
releasing. Push the ▼ key or the ▲ key to flash ON
or OFF on the display.
4. Push the ENTER key
or
Screen just before pushing the MODE MODE MODE MODE key.
•
Push the ENTER key.
•
When you turn on the hold function:
⇒ ⇒ ⇒ ⇒ The display shows the temperature measured at the
execution of the hold function.
⇒ ⇒ ⇒ ⇒ The sub display flashes.
•
When you turn off the hold function:
⇒ ⇒ ⇒ ⇒ The display returns to the screen shown just before
you have pushed the MODE key.
Setting Releasing
Releasing Setting
Setting Releasing
(Latest measured
temperature)