Wasp Barcode WLS9600 Product Reference Guide - Manual (Page 41)

ENTER/EXIT PROGRAMMING MODE Disable Character
Product Reference Guide 31
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
Data Bits has been set as
7 Data Bits.
See page 237 for more information on setting this feature.
Select Disable Character Setting
DEFAULT 0x44 = Disable Character is ‘D’
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
Data Bits has been set as
7 Data Bits.
See page 238 in “References” for more information on setting this feature.
Select Enable Character Setting
DEFAULT 0x45 = Enable Character is ‘E’