Scanning features, Scan mode, In “ref – Wasp Barcode WLS9600 Product Reference Guide User Manual
Page 264

References
254
WLS9600
Scanning Features
Scan Mode
This mode is associated with typical handheld reader operation. Selects the scan operating mode
for the reader. The following selections are valid for all models:
Trigger Single.
When the trigger is pulled, scanning is activated until one of the following
occurs:
-
has elapsed
- a label has been read
- the trigger is released
Trigger Hold Multiple.
When the trigger is pulled, scanning starts and the product scans until
the trigger is released or
has elapsed. Reading a label does not disable
scanning.
prevents undesired multiple reads of the same label while in
this mode.
Trigger Pulse Multiple.
When the trigger is pulled, continuous scanning is activated until
has elapsed or the trigger has been released and pulled again.
prevents undesired multiple reads of the same label while in this mode.
Flashing.
The reader flashes
1
on and off regardless of the trigger status. Flash rate is controlled
. When Flash is ON the imager reads continuously; when
Flash is OFF scanning is deactivated.
Flashing is the recommended scan mode for WLS9600 hands-free
(stand mode) of operation
Always On.
No trigger pull is required to read a barcode. Scanning is continually on. If the
trigger is pulled, the reader acts as if it is in Trigger Single Mode.
prevents undesired multiple reads of the same label while in this mode.
.