Wasp Barcode WLS9600 Product Reference Guide - Manual (Page 25)

Product Reference Guide 15
Chapter 3
Configuration Using Barcodes
This and following sections provide programming barcodes to configure your reader by
changing the default settings. For details about additional methods of programming, see
Configuration Methods on page 3 .
You must first enable your reader to read barcodes in order to use this
section. If you have not done this, go to
Setup, starting on page 5 and
complete the appropriate procedure.
Configuration Parameters
Once the reader is set up, you can change the default parameters to meet your application needs.
Refer to
"Standard Defaults" starting on page 265 for initial configuration in order to set the
default values and select the interface for your application.
The following configuration parameters are divided into logical groups, making it easy to find
the desired function based on its reference group.
Interface Configuration:
• "RS-232 ONLY Interface" on page 19
• "RS-232/USB-Com Interfaces" on page 24
• "Keyboard Interface" on page 33
• "USB-OEM Interface" on page 45
• "Wand Emulation Interface" on page 47
Parameters common to all interface applications:
• "Data Format" on page 51 gives options to control the messages sent to the Host system.
• "Reading Parameters" on page 65 control various operating modes and indicators status
functioning.
Symbology-specific parameters:
• "Code Selection" on page 77 provides configuration of a personalized mix of codes, code
families and their options.
Model-specific parameters:
• "Laser Features" on page 227 provides options specific to laser models.