Wasp Barcode WLS9600 Product Reference Guide - Manual (Page 277)

Standard Defaults
Product Reference Guide 267
READING PARAMETERS
Double Read Timeout 0.6 Second 65
Label Gone Timeout 160 ms 67
Power On Alert 4 Beeps 68
Good Read: When to Indicate After Decode 68
Good Read Beep Type Mono 69
Good Read Beep Frequency Medium 69
Good Read Beep Length 80 ms 70
Good Read Beep Volume High 71
Good Read LED Duration 300 ms 72
Scan Mode Trigger Single 73
Scanning Active Time 5 Seconds 74
Flash On Time 1 Second 74
Flash Off Time 600 ms 75
Green Spot Duration 300 ms 75
Code Selection
Coupon Control Enable UPCA coupon
decoding
79
UPC-A
UPC-A Enable/Disable Enable 80
UPC-A Check Character Transmission Enable 80
Expand UPC-A to EAN-13 Don’t Expand 81
UPC-A Number System Character Transmission Transmit 81
UPC-A Minimum Reads 1 82
UPC-E
UPC-E Enable/Disable Enable 83
UPC-E Check Character Transmission Send 83
Expand UPC-E to EAN-13 Don’t Expand 84
Expand UPC-E to UPC-A Don’t Expand 84
UPC-E Number System Character Transmission Transmit 85
UPC-E Minimum Reads 2 85
Parameter Default Your Setting
Page
Number