Wasp Barcode WLS9600 Product Reference Guide - Manual (Page 275)

Product Reference Guide 265
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for feature descriptions and programming barcodes for each
parameter. A column has also been provided for recording of your preferred default settings for
these same configurable features.
Table 49. Standard Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore Obey 17
USB Suspend Mode Disable 17
RS-232 ONLY
Baud Rate 9600 20
Data Bits 8 Data Bits 21
Stop Bits 1 Stop Bit 21
Parity None 22
Handshaking Control RTS 23
RS-232/USB-Com
Intercharacter Delay No Delay 25
Beep On ASCII BEL Disable 25
Beep On Not on File Enable 26
ACK Character ‘ACK’ 28
NAK Character ‘NAK’ 28
ACK NAK Timeout Value 200 ms 29
ACK NAK Retry Count 3 Retries 29
ACK NAK Error Handling Ignore Errors Detected 30
Indicate Transmission Failure Enable 30
Disable Character ‘D’ 31
Enable Character ‘E’ 31