I 2 of 5 set length 2, Default – Wasp Barcode WLS9600 Product Reference Guide User Manual
Page 155

ENTER/EXIT PROGRAMMING MODE
I 2 of 5 Set Length 2
Product Reference Guide
145
I 2 of 5 Set Length 2
This feature specifies one of the barcode lengths for
Mode, or the second fixed length if in
Mode. The length includes the barcode’s check and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
provides examples for setting Length 2. See
for detailed instructions on setting
this feature.
Table 9. I 2 of 5 Length 2 Setting Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
Ignore This
Length
4 Characters
14 Characters
50 Characters
2
Pad with leading zeroes to
yield two digits
00
04
14
50
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT I 2 OF 5 LENGTH 2 SETTING
5
Scan Two Characters From
‘0’ and ‘0’
‘0’ and ‘4’
‘1’ and ‘4’
‘5’ AND ‘0’
6
Scan ENTER/EXIT PROGRAMMING MODE
Select I 2 of 5 Length 2 Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters