Reading configuration barcodes – Wasp Barcode WLS9600 Product Reference Guide User Manual
Page 26

16
WLS9600
Reading Configuration Barcodes
You must first enable your reader to read barcodes in order to use this
section. If you have not done this, go to
complete the appropriate procedure.
To program features:
1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each pro-
gramming page, when applicable.
2. Scan the barcode to set the desired programming feature. You may need to cover unused
barcodes on the page, and possibly the facing page, to ensure that the reader reads only the
barcode you intend to scan.
3. If additional input parameters are needed, go to
, and scan the appro-
priate characters from the keypad.
Additional information about many features can be found in the “Refer-
ences” chapter.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
MING barcode to exit Programming Mode.
For detailed descriptions, programming information and examples for setting selected
configuration items, see