MacDon FD75 OM - Manual (Page 5)

List of Revisions
The following lists the changes from the previous version (169595 Revision D) of this document.
Summary of Change Refer To
Note regarding access to updated manuals added to
Introduction
Introduction, page ii
25 ft. FD75 deleted All locations
Specifications table revised 3 Specifications, page 27
CA25 oil change interval revised Changing Oil in Header Drive Gearbox, page 273
Optimizing the header for straight combining canola
section added 4.6.3 Optimizing Header for Straight Combining Canola,
page 48
Wing Float procedure revised
6.14 Checking and Adjusting Header Wing Balance,
page 390
Operating in flex mode and in rigid mode sections
added
Operating In Flex Mode, page 143
Operating In Rigid Mode, page 144
John Deere combine coupler attachment procedure
revised 5.3.1 Attaching Header to John Deere Combine, page
198
Optional attachments section updated 8 Options and Attachments, page 415
Cutting on the ground section revised Cutting On the Ground, page 55
Header Float section revised 4.7.3 Header Float, page 137
AHHC section reorganized 4.7.2 Auto Header Height Control, page 56
Reel Speed, Ground Speed, Draper Speed and Knife
Speed sections revised
4.7.5 Reel Speed, page 146
4.7.6 Ground Speed, page 147
4.7.7 Draper Speed, page 148
4.7.8 Knife Speed, page 150
References to HC10 Hay Conditioner deleted All locations
CR Feeder Deflector section revised 5.5.3 CR Feeder Deflectors, page 220
Multicoupler topic deleted Various locations
Installing and removing flighting extensions, feed
deflectors, and stripper bars moved to Maintenance
and Servicing.
6.7.6 Flighting Extensions, page 298
6.10 Adapter Stripper Bars and Feed Deflectors, page
332
Auger to Plan Clearance, and Auger Drive Chain
Tension revised
6.7 Auger, page 286
6.7.2 Adjusting Auger Drive Chain Tension, page 287
Major changes to Knife and Knife Drive sections
Various locations including 6.8 Knife and Knife Drive,
page 300
Knife hold-down clearances revised Knife Hold-Downs, page 309
169894 iii Revision A