MacDon FD75 OM User Manual
Page 333
NOTE:
For ease of removing or installing knifehead pin,
remove grease zerk from pin.
8.
Install knifehead pin (A) through the output arm and
into the knifehead.
9.
Align groove (B) in knifehead pin 0.06 in. (1.5 mm)
above (C). Install 5/8 in. X 3 in. hex head bolt and
nut (D) and torque to 160 ft·lbf (217 N·m).
Figure 6.130: Knifehead
10. Install grease zerk (A) into the knifehead pin, turn the
grease zerk for easy access.
IMPORTANT:
Grease knifehead just enough to start a
slight
downward
movement
of
knifehead.
Over-greasing will misalign knife, causing guards
to overheat and overload the drive system.
Figure 6.131: Knifehead
11. Check the knife drive box pulley and drive pulley
alignment.
If adjustment is required, contact your
MacDon Dealer.
12. Tighten knife drive box side bolts (A) first, then the
bottom bolts (B). Torque to 200 ft·lbf (271 N·m).
13. Stroke the output arm to mid stroke, check and ensure
that the knife bar does not contact the front of the first
guard. If adjustment is required, contact your MacDon
Dealer.
14. Install and tension the knife drive belt(s).
Refer to
Tensioning Knife Drive Belts, page 313
15. Close endshield. Refer to
Figure 6.132: Knife Drive Box
169894
319
Revision A