10adapter stripper bars and feed deflectors, 1installing stripper bars, 2removing stripper bars – MacDon FD75 OM User Manual
Page 346: Adapter stripper bars and feed deflectors, Installing stripper bars, Removing stripper bars, 10 adapter stripper bars and feed deflectors, 1 installing stripper bars, 2 removing stripper bars
6.10
Adapter Stripper Bars and Feed Deflectors
6.10.1
Installing Stripper Bars
To install stripper bars to the adapter, follow these steps:
1.
Detach header from combine.
Refer to
Attachment/Detachment, page 189
for your specific
combine.
2.
Position stripper bar (A) so notch (B) is at corner of
frame. Secure it to the adapter with four bolts (C) and
nuts. Nuts toward combine.
3.
Repeat for opposite side .
4.
Attach header onto the combine, Refer to
Attachment/Detachment, page 189
Figure 6.158: Stripper Bar
6.10.2
Removing Stripper Bars
To remove stripper bars from the adapter, follow these steps:
1.
Remove four bolts and nuts (A) securing stripper bar
(B) to adapter frame, and remove bar.
2.
Repeat for opposite side.
Figure 6.159: Stripper Bar
169894
332
Revision A